An AC running but not cooling is one of the most frustrating problems in a Texas summer. There are few things worse in a San Antonio summer than hearing your AC run nonstop while the house keeps getting warmer. When your AC is running but not cooling, the most common causes are a clogged air filter, a dirty indoor or outdoor coil, a frozen evaporator coil, thermostat settings, a tripped breaker or disconnect on the outdoor unit, leaky ductwork, or low refrigerant. Some of these you can check yourself in minutes. Others need a professional. This guide walks through them in the order that makes the most sense.
If you smell burning, hear grinding or loud banging, or see ice building up, turn the system off and call a professional before running it again.
Why Your AC Is Running but Not Cooling: Step-by-Step Checks
Step 1: Check the Thermostat
- Mode: Make sure it’s set to “Cool,” not “Heat” or “Fan.”
- Fan setting: If the fan is set to “On” instead of “Auto,” it will blow air even when the AC isn’t actively cooling, which can feel like warm air coming from the vents.
- Batteries and schedule: Dead batteries or a programmed schedule can cause confusing behavior.
- Location: A thermostat in direct sun or near a heat source may think the house is hotter or cooler than it really is.
Step 2: Look at the Air Filter
A clogged filter is the most common and easiest fix. When airflow is restricted, the system can’t move enough air across the indoor coil to cool your home. In severe cases, the coil can even freeze. Pull the filter and hold it up to a light. If you can’t see light through it, replace it. During our long cooling season, many homes need a new filter every one to two months.
Step 3: Check the Outdoor Unit
- Is the fan spinning and the unit humming? If the indoor blower is running but the outdoor unit is silent, check the breaker in your electrical panel and the disconnect switch near the outdoor unit.
- Is the coil covered in debris? Grass clippings, leaves, cottonwood fluff, and dirt on the outside fins keep the unit from releasing heat. With power off, gently rinse it with a garden hose from the inside out if you can, or from the outside in with low pressure.
- Is it crowded? Shrubs, fences, and stored items should be at least two feet away.
Step 4: Look for Ice
It sounds strange in July, but ice on the indoor coil or the copper refrigerant line is a common cause of poor cooling. Ice blocks airflow and stops heat transfer. Common causes include dirty filters, dirty coils, blocked return vents, and low refrigerant. If you see ice, switch the thermostat to off and the fan to on to help it thaw, and call for service. Don’t chip at the ice.
Step 5: Check Vents and Returns
Make sure supply vents are open and not blocked by furniture, rugs, or curtains. Return vents, usually larger grilles in hallways or ceilings, also need clear space. Closing too many vents to “save energy” can actually reduce airflow and hurt cooling.
Step 6: Consider Dirty Coils
Even with a clean filter, dust and grime build up on the indoor evaporator coil over time. Because the coil is wet while the AC runs, dust sticks to it easily. A dirty coil can’t absorb heat well, so the system runs longer and delivers less cooling. If it’s been more than a year since your coils were cleaned, this is a likely factor. Learn more about AC coil cleaning.
Step 7: Think About Ductwork
In many San Antonio homes, ducts run through the attic, where temperatures climb far above the outdoor air on summer afternoons. Leaky, disconnected, or poorly insulated ducts can lose a lot of cool air before it reaches your rooms. Signs include some rooms being much warmer than others, weak airflow from certain vents, or dusty air. Dirty, restricted ducts can also reduce airflow. Professional air duct cleaning and a duct inspection can help.
Step 8: Remember the Attic
Thin or missing attic insulation lets heat pour down into your living space and makes it harder for even a healthy AC to keep up, especially upstairs. If your system is working but the house still feels warm, your insulation may be part of the problem. See our home insulation services.
When to Call an HVAC Technician
Some causes require licensed HVAC repair:
- Low refrigerant: Usually means there’s a leak that needs to be found and repaired.
- Failing capacitor or contactor: Common in Texas heat; the outdoor unit may hum but not start.
- Compressor or fan motor problems.
- Clogged condensate drain that triggers a safety switch.
Is It the AC or Just the Heat?
On extreme days, even a healthy system may only keep the house about 15 to 20 degrees cooler than outside. If it’s 105 outside and your home holds at 78 to 80 in late afternoon but cools down in the evening, your AC may simply be at its limit. Keeping blinds closed on sunny windows and avoiding oven use in the afternoon helps.
Related reading: Evaporator vs. Condenser Coil Cleaning: What’s the Difference? and What to Check in Your HVAC System After a Texas Storm.
Frequently Asked Questions
Why is my AC blowing air that isn’t cold?
Common reasons include a dirty filter, dirty coils, a frozen coil, an outdoor unit that isn’t running, or low refrigerant.
Can dirty ducts cause poor cooling?
Heavy buildup or leaky ducts can reduce airflow and waste cooled air, making rooms feel warmer.
How can I prevent this next summer?
Change filters regularly, keep the outdoor unit clear, and schedule coil cleaning and system maintenance before the hottest months.
Get Your Cooling Back on Track
Top Green Air Duct helps homeowners in San Antonio, Helotes, Boerne, New Braunfels, Converse, Schertz, Seguin, and Timberwood Park with coil cleaning, duct cleaning, and insulation. Call (830) 432-2121 or request a free estimate.
Need Help With Your Home’s Air?
Top Green Air Duct serves San Antonio, Helotes, Boerne, New Braunfels, Converse, Schertz, Seguin, and Timberwood Park. Free estimates, no bait-and-switch pricing.